Parts

CL 863009

O-Ring

DY 01036

Bearing

DY 54520

Bearing

GG 15G998

UHMW Washer

GG 15K649

HOUSING,WIDE RATIO,10:1

GG 24A352

Kit, Air Valve, Medium, Std

GG 24A551

KIT, SEALS MOTOR, 7.5

Graco 24A551 Air Motor Seal Kit

GG 24C780

Needle, Assembly

GG 25P700

KIT, FUSION PC, RETRO, RND, 00

Fusion ProConnect Retrofit Kit with Round 00 Mix Chamber and 0.029 in (0.74 mm) Orifice Size Transform your Fusion Air Purge gun into a Fusion PC with the ProConnect Retrofit Kit, allowing you to take full advantage of what the Fusion PC delivers: A perfect rebuild in seconds. The Retrofit Kit is compatible with all Fusion AP guns and is available in multiple mix chamber sizes. Acquire all the advantages of the revolutionary Fusion ProConnect while utilizing your existing Fusion AP handle and fluid manifold. Same Fusion AP gun, all new possibilities A single cartridge replaces the entire fluid section in seconds Sprays exactly like a Fusion AP Integrated check valves for cross-over containment 13 parts are replaced by a single ProConnect cartridge Eliminates the need to purchase fluid section o-rings Spare ProConnect cartridges can replace your back-up guns

GG 269725

CONTRACTOR FLAT TIP, SPRAY

Graco 269725 Contractor Flat Tip, 725

The 725 Contractor Flat Tip produces a 14 to 16 inch fan and has a 0.025 inch orifice.

• Model: Contractor
• Series: Flat Tip
• Compatible Material: Architectural Coating
• For Use With: Silver Plus Airless Spray Gun
• Maximum Fan Width (cm): 35
• Maximum Fan Width (in): 14
• Maximum Fan Width (mm): 406
• Maximum Flow Rate (GPM): 0.67
• Maximum Flow Rate (L/min): 2.54
• Maximum Working Pressure (bar): 345
• Maximum Working Pressure (kPa): 34500
• Maximum Working Pressure (psi): 5000
• Minimum Fan Width (in): 14
• Minimum Fan Width (mm): 356
• Orifice Diameter (in): 0.025
• Pattern Size (in): 14 to 16
• Pattern Size (mm): 355.6 to 406.4